Ditemukan 11 dokumen yang sesuai dengan query
New York: The American Society of Mechanical Engineers, 1985
621.18 STE
Buku Teks Universitas Indonesia Library
New York: The American Society of Mechanical Engineers, 1981
621.406 GAS
Buku Teks Universitas Indonesia Library
New York: American Society of Mechanical Engineers, 2018
600 JERT
Majalah, Jurnal, Buletin Universitas Indonesia Library
"
ABSTRAK
A comparative study is presented of several models describing steady-state heat flow through an assembly consisting of a primary surface (wall) and attached extended surface (fin). Attention is focused on the validity of four performance indicators. The work shows that the augmentation factor is the only indicator capable of correctly predicting the behavioral trends of the rate of heat flow through the assembly as the influencing physical parameters are varied ...
"
New York: American Society of Mechanical Engineers, 2018
620 JHT
Majalah, Jurnal, Buletin Universitas Indonesia Library
"
Experimental results from a gas thrust bearing test facility are reported in this paper. This fundamental investigation of the thermo-fluid dynamics of a gas lubricated bearing forms part of a wider progamme aimed at their introduction into the aeroengine environment ...
"
New York: the American Society of Mechanical Engineers, 2018
620 JAM
Majalah, Jurnal, Buletin Universitas Indonesia Library
New York: the American Society of Mechanical Engineers, 2018
620 JTM
Majalah, Jurnal, Buletin Universitas Indonesia Library
New York: American Society of Mechanical Engineers, 2018
620 JEI
Majalah, Jurnal, Buletin Universitas Indonesia Library
New York : American Society of Mechanical Engineers, 2018
621 JMD
Majalah, Jurnal, Buletin Universitas Indonesia Library
New York : American Society of Mechanical Engineers, 2018
621 JMD
Majalah, Jurnal, Buletin Universitas Indonesia Library
"
ABSTRAK
The purpose of this study is to investigate the flow patterns of a falling liquid film as observed near an obstacle on a flow channel. In this report, a bend on the channel was chosen as the obstacle and the behavior of a ring-shaped swelling of the liquid film, which appears near the obstacle at a low flow rate, is considered. The Weber number at which the swelling shifts from upstream to downstream of ...
"
New York: American Society of Mechanical Engineers, 2018
620 JFE
Majalah, Jurnal, Buletin Universitas Indonesia Library
